Search:

Type: Posts; User: ricohtoshiba

Search: Search took 0.01 seconds.

  1. thanks for the info,, i will check those...

    thanks for the info,, i will check those scenarios,, power shortages, fuser, door switches.
  2. e-803 is the error code

    e-803 is the error code
  3. clc 1110 turns off a few seconds after i turn it on

    my canon cl1110 machine turns off just a few seconds after i turn it on.

    i turn the main power toggle switch on , seconds later the main power toggle switch just turns off by its self it seems.
    ...
  4. Replies
    14
    Views
    3,418

    ok, found it, after entering service mode it's ...

    ok, found it, after entering service mode it's *4* then scroll right once to the "error" reset screen, then press * . yay.
  5. Replies
    14
    Views
    3,418

    ok,, what you replied makes absolute no sence to...

    ok,, what you replied makes absolute no sence to me , i cannot find an OK key.
    however i am at the point where i can enter service mode by pressing the service button hidden in the front cover, ...
  6. Replies
    14
    Views
    3,418

    np6551 Fuser Web Reset

    The web ran out and error 005 shows

    I can't seem to get into service mode on the NP6551, maybe i'm doing it wrong, i have no service manual for this machine so i'm wingin it from another model.
    ...
  7. Replies
    5
    Views
    1,482

    I'm sorry i relayed the info incorrectly here is...

    I'm sorry i relayed the info incorrectly here is the exact problem

    i put a document in the document feeder, the lift plate lifts the originals up to the pickup tire,
    i press the start button,...
  8. Replies
    5
    Views
    1,482

    MP 6000 unfinished job at exit

    the copier works for a bit then says on the display "unfinished job at exit" Document feeder related i know this much.

    if anyone has some info on this please reply. thank you in advance.
  9. Replies
    6
    Views
    5,749

    thank you for the reply, turns out that i was...

    thank you for the reply, turns out that i was doing the firmware in the wrong sequence,, i downloaded the "Boot" to the copier first. After doing the firmware again with "boot" Last on the sequence...
  10. Replies
    6
    Views
    5,749

    IR5000 e602-004

    The copier started with the error e602-003 which points to hard drive corrupted. I replaced the HDD and did the firmware, which all seemed to go fine. Now when i boot up the copier it goes into...
Results 1 to 10 of 10