Search:

It must have been attracted by the wire nuts. =^..^=

Cyan developing isn't that great. Not sure if it will help. =^..^=

Good luck. that's just how they are.

A firmware upgrade could take up to 1 hour, waiting for the machine to boot back up in 08 mode, after the firmware. I'm glad those machines are gone. =^..^=

Congratulations on your success. =^..^=

During the time that I was moderating United Techs Online we got between 12-50 spam memberships every single day, often the same spammers again & again & again. Email activation filtered out 75% of...

You may have paper scraps in the registration inlet, that are difficult to remove:

Misfeeds duplex J3209, J3101, J3120. Jam clears but returns. Paper jam is difficult to recover from the lower...

There are about a million things that can cause EB50's. I think that I documented it pretty well in this thread here:
...

So what model was this? =^..^=

Sure, you'll still get a C970 ... and those bars crossfeed will have become magenta, or cyan, or yellow, depending on where you move that charge unit.



That is going to be the main problem. Any...

If you think it's the drum, swap that drum to another unit, say magenta, and see if the quality issue becomes magenta.

What did you not understand about swapping the primary charge unit to another...

Sadly, axyun hasn't been here since 7/31/2020. I hope everything is all right with him.

My suggestion is to post into his thread and see if he responds (he'll get an automation email to threads...

Welcome! =^..^=

Welcome! =^..^=

What's you're precise paper size?

8K is 10.51in x 15.28in or 260mm x 368mm
08-4100 set to 144 should have worked only until you run out of paper for the first time. It is reset automatically...

The C970 is almost always caused by a shorting primary charge unit, which will coincide with your image quality issue ... so black. Often the post that the spring or grid attach to snaps off, but the...

Here are the service manual sections that you need:

So it won't load the disassembly portion (too large).

It's a Swedish spammer advertising for casinos.

Do you mean the warmup time to come to "Ready"?
What media type settings are designated for each drawer?
What is the toner level at? Maybe almost empty?
What does your manual say about warmup time...

It's unlikely to be a power supply. I'd say your best chances are with the system board.

There's an odd chance that you've got a dead short or pinched wire in another component that's running off...

Good point. The chassis should always be grounded to avoid arcing, possibly damaging boards.

My first vacuum did not have a ground contact through the hose, so when vacuuming developer you'd get:...

You can buy C13 & C14 connectors and make your own cord ... or buy a cord C13 to C14.

It didn't look too dangerous to me, just awkward explaining all the black tape when the customer asks.
...

Most likely, there's an error code that they're not telling you about.

Funny thing about error codes ... it will be the only thing on the screen, and the enduser says: "nope there's nothing on the...

Welcome! =^..^=

Welcome! =^..^=

Welcome! =^..^=