Search:

Type: Posts; User: rockdude

Page 1 of 10 1 2 3 4

Search: Search took 0.01 seconds.

  1. [Electrical] Re: Xerox J75 printing light gray background from edge to edge !?

    I have not had this happen on the J75, but have had the grey issue on similar models.

    Sometime across entire page, sometimes just around the edge.

    In my case replacement of High Voltage power...
  2. Replies
    2
    Views
    251

    Re: ColorQube 8570

    I know this may sound "crazy" but I had same problem.

    I replaced the "Pre-Heater Desqew" and that solved the problem.
    (My next choice would have been the "Media Drive Assembly")

    Let us know...
  3. Re: Need IBM Wheel Writer 6 Repair and Parts Manual

    That did Thank You !!
  4. Thread: Xerox Parts

    by rockdude
    Replies
    11
    Views
    815

    Re: Xerox Parts

    Best bet for parts that aren't listed, is to show a picture of the whole assembly,
    then highlight the portion of that assembly that you are looking for.

    As the saying goes "One picture is worth...
  5. Need IBM Wheel Writer 6 Repair and Parts Manual

    I realize I am asking for some old stuff here, just hoping I can get lucky.

    Looking for the service and parts manual for the IBM Wheel Writer 6 typewriter.

    I have lots of other manuals to...
  6. Replies
    6
    Views
    367

    Re: Xerox B405 Maint Kit message wont clear

    Please ignore my post above.

    That should have been for the B8045 forum.

    My eyes playing tricks on me.
  7. Replies
    6
    Views
    367

    Re: Xerox B405 Maint Kit message wont clear

    I have had that occur before, as well as a phantom jam that wouldn't go away.
    (I have had this on four machines)

    Turned out to be the main board, and then after replacement a full ALTBOOT with...
  8. Replies
    24
    Views
    1,651

    Re: The End of Xerox's ASP program

    It looks like cutoff date (to be able to order warranty parts or file a labor claim) is June 1, 2021

    Mark it on your calendar. R.I.P. Xerox ASP Program
  9. Replies
    24
    Views
    1,651

    The End of Xerox's ASP program

    As of June 1 2021 Xerox is essentially firing all ASP's from doing any warranty or service contract work.

    No more "Warranty reimbursement claims"

    No more "No Charge for Warranty Parts"
    ...
  10. Replies
    6
    Views
    497

    Re: GSN lock & bus station question

    We were told the same thing as "Rusty"

    Separate "TCN" numbers but only one "GSN" number for the dealership.

    Although this may all become a moot point as of June 1 2021 Xerox is essentially...
  11. Replies
    1
    Views
    626

    Re: Looking for techs based in Miami

    I work on Xerox and HP 30 years experience.

    I only work in Broward and Palm Beach county.

    Contact me at service@rtbt.com if you are interested.
  12. Replies
    0
    Views
    119

    Is this a Epson HOAX ?

    I got the email below this morning.

    Hi Jim XXXXXX,


    You have been enrolled in the following online course:

    Epson WorkForce Enterprise WF-C20590, WF-C17590 and M20590

    You can access...
  13. Replies
    1
    Views
    360

    [Dead] Re: Altalink C8055, WC7855

    Is it totally dead? (power but will not boot)

    Then you need firmware (altboot procedure)

    A little more information as to what state the machine is in, as well as what you hope to accomplish...
  14. Replies
    2
    Views
    329

    Re: Xerox 7835 always ask for toner

    Are you sure you are putting "Retail" (sold) toner and not metered toner?

    Machine will keep asking for "toner" if the incorrect toner (Metered or Sold) is put in.

    Check Config Sheet if...
  15. Re: Short on Altalink B8055 "Jam Behind Left Door"

    Well it looks like I will never know for sure. The customer had me replace all the possible items I thought it might be. I know it had Blown the ITXO PWB, I also replaced the left door assembly...
  16. Replies
    2
    Views
    257

    [Misc] Re: Printer offline when doing copies

    A little more info would be helpful.

    You "Didn't" say what version of firmware you were using?

    You also "Didn't" say if the firmware you used with the "Altboot" was same as original firmware?
    ...
  17. Short on Altalink B8055 "Jam Behind Left Door"

    I have a Altalink B8055 that is showing "Jam Behind Left Side Door". (There is "NO" jam behind door.)

    I used diagnostics to check the seven sensors that can cause this error.

    They all read...
  18. Re: How to reset TASKalfa 4002i Command Centre Password for Admin

    I take it you want me to do a U026 to restore back the data to the SSD?

    Will it also put back the old Password? (The one I don't know)

    Thanks
  19. How to reset TASKalfa 4002i Command Centre Password for Admin

    Does anyone know how to reset the TASKalfa 4002i Command Centre Password for Admin?

    Need this to login and make some scan to email changes (Gmail)

    Someone changed it from Admin/Admin (User Name...
  20. Re: Looking for Kyocera TaskAlfa 4002i,5002i,6002i, Service Manual

    Thanks, All good here.

    If you need any Xerox stuff (Manuals, Firmware, Parts, etc.) let me know in a PM.

    Take care and thanks again.
  21. Re: Looking for Kyocera TaskAlfa 4002i,5002i,6002i, Service Manual

    I have requested access.

    Check your email as well.
  22. Re: Looking for Kyocera TaskAlfa 4002i,5002i,6002i, Service Manual

    Sent my email in PM to you.

    I Have the Xerox Manuals you want as well
  23. Looking for Kyocera TaskAlfa 4002i,5002i,6002i, Service Manual

    Looking for Kyocera TaskAlfa 4002i,5002i,6002i, Service Manual.

    Have Xerox service manuals to trade.

    Thanks

    Rockdude
  24. Replies
    3
    Views
    1,510

    Re: Xerox WC 6515 Toner problem

    Non-OEM toners are famous for causing developer run off.

    Basically the color doesn't match what Xerox thinks it should be, so it gives it more developer.

    As you were told this usually means...
  25. Re: Workcentre 3550 HELP metered Toner when it shouldn't be

    I just usually call into Xerox, give them the serial number and a page count, and they send me a snippet that resets the machine back to "Neutral"
    (Will then set to whatever cartridge is first put...
Results 1 to 25 of 236
Page 1 of 10 1 2 3 4