Kip 7170 service entry

[kenoking]

Looking for service entry to check fuser speed for voiding on long prints. Had a manual, then had a flood in business. Manual go bye bye.
Any help would be appreciated. I found 7170k online but not the same animal I do not believe.

[blackcat4866]

Re: Kip 7170 service entry

Does it look like this?:

I caused this issue after changing a drum. The cast aluminum drum retainers/brackets were incorrectly seated, causing the paper to ripple while passing below the drum. I got a bulletin from Kip that was supposed to resolve the issue adjusting motor speeds. I spent ~ 2 days on this problem. Eventually our KM rep came out and found the retainer issue.

I can include the bulletin, but for me, it was the wrong path to a solution.

You can remove the side covers, and watch the paper passage ... seeing the ripple begin. Here is my database entry:

Voids areas of a seemingly random shape, on 18" & 24" wide paper, and 17.5" from trailing edge, seen on Arch D sized images and larger. Missing pieces of image appear 9.88" further down the page. Replaced pressure roller (Z164400850), bearings ([2]9000780174), nail set lower-set of 7 (Z160980130). Adjusted fuser motor speed in BUD 702 (40 > 0) for some improvement. Transfer issue? Re-position drum mounts, so that the bearings seat properly, and the mount fits tight to the frame.

I pulled out a lot of my remaining hear on this issue.
=^..^=