Thanks:
0
Likes:
0
Dislikes:
0
-
Junior Member
- Rep Power
- 0
Meandering fusing belts
Hi
Ive recently been having trouble with fusers from the sphinx, pheonix, griffen range of machines (2630,3560,5070 etc), ive had a few in recent weeks were the fusing belt meanders to one side and tears itself to bits. All of these machines had the belt rip before there first service interval was up. Im aware of the firmware updates that addressed the initial issues these fusers had and the switch to the MX600FB fusing belt. All machines have the most up to date firmware and most would have came with the MX600fb from the factory but ive seen this happen on the 607 and 608 belts too.
Has anyone else seen this specific problem?, i know these fusers arnt well regarded but for the most part i hadnt had any issues with them until now.
-
Re: Meandering fusing belts
Same here, 5 times and all send to Sharp.
They send us new without comment.
Next one with H4-02
Meandering to the front
Last edited by OlliK1969; 09-25-2019 at 03:49 PM.
-
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks