MX-6580N - APPD1_N

[MHeon71]

Not a constant, but frequent. Could happen every 10 pages or it could go 180 pages. It makes it past the gate to go down the ADU, but does not make it to the transport rollers and it only seems to happen when the paper comes to a stop during the weaving part of the duplexing.

The copier is only a week old, mylars are in good condition and properly installed. No bures on guides. Changed adjusting ADU registration in TC 51-2 (engine) L and M from 20 to 40. Same issue.

I will be going back today. I will be bringing fresh quality paper (Hammermill). They are currently using Staples paper and I think the paper has moisture in it.

Thanks for any help.

[spanky]

See attached bulletin, don't know if it will help you.

[MHeon71]

Thanks Spanky, they were already set to 62. I did run a ream of Hammermill with no issues. I guess I may be all set.

[Phil B.]

Thanks Spanky, they were already set to 62. I did run a ream of Hammermill with no issues. I guess I may be all set.

I try to spank my customers HARD when I catch them using the crap STAPLES shit.. no constant QA levels ..sometimes short grain paper..sometimes long grain but ALWAYS toooooo much powder !

CRAP PAPER!

Hammermill is good paper!