Sharp MX 4141

[Reed]

I went out on a Sharp MX 4141 yesterday. When you turn it on the machine comes to ready and the control panel is responsive. Then machine is not connectected to a network. If I try to make a copy the machine freezes up and becomes unresponsive. I tried to perform a 66-10 image clear but nothing seems to happen. After rebooting several times I was able to get the machine to make copies and internal prints but when I power cycled the machine again. It had the same issues Any Ideas. Thanks in advance

[EasyRider]

Cheap and (somewhat) easy is firmware first and if that doesn't help, re-do or replace the sd card.
Good luck!

[copiertec]

I went out on a Sharp MX 4141 yesterday. When you turn it on the machine comes to ready and the control panel is responsive. Then machine is not connectected to a network. If I try to make a copy the machine freezes up and becomes unresponsive. I tried to perform a 66-10 image clear but nothing seems to happen. After rebooting several times I was able to get the machine to make copies and internal prints but when I power cycled the machine again. It had the same issues Any Ideas. Thanks in advance

Ditto, on what Easyrider said.

[repn1999]

first i would say sd card....if not that maybe replace the entire operation panel. I know this sounds wierd.....but I have seen these act where the screen was frozen but it would still print and the webpage still would work. it was 50/50 in the senario as to which one it was. also....check the wall voltage. power cannot drop below 110v EVER....and ground to neutral must be less than 2v.

[youfster]

Hey did you manage to sort this out? Seeking firmware for the same model.

[MattL]

Try clearing the job log as well as the above.