HI all, so 2 weeks ago I attended a MX6070 with the classic faded grey 'Tiger' stripe prints being produced. The drum/charge etc was only on 58%, so I cleaned everything out and cleaned the machine and fitted new developer, set it up and it was all fine again. Had to go back this morning for the same problem, its lasted 11 days and done 32K but had the exact same problem. So this time I have replaced the drum and fitted a new MK Kit as well and new dev. cleared counters, set everything back up and calibrated the machine. I am now hoping that has fixed it but wondered if anyone of you have had a similar problem and it was something else? The firmware isnt on the very latest but its been done in the last 6 months.
Bookmarks