Also check...
Systems Settings...(login as admin)....Printer Settings....Default settings....Print Density Level
default is 3
If you did factory reset these should be back at 3 already, but worth a peak
I got the system rebooted up. I think i may have accidentally flipped to "boot from SD" switch to OFF, when wrestling with the card. Everything is functioning as it was before (faded prints) with the original SD card. I will attempt to image the old card onto a new card in a bit.
Print and post a 22-6.
Also send a print job.....quantity 5.
when first print begins to exit open the front door.
pull out primary transfer.......iis the image faded on the belt prior to secondary transfer?
MX-3110N_20201021_162635.pdf - Google Drive
here is a link to the 22-6
Bookmarks