Thanks: 
Likes: sorry if any of this has been covered before.....
will machine print an internal print, sim 64-4?
I know you said it prints from USB, but will it print from HDD. Store doc on machine via Doc Storage, will a stored doc print directly from HDD?
Dislikes: 0
sorry if any of this has been covered before.....
will machine print an internal print, sim 64-4?
I know you said it prints from USB, but will it print from HDD. Store doc on machine via Doc Storage, will a stored doc print directly from HDD?
Sounds like a read/write problem for the print memory. You can go into SIM mode and perform a read/write test for the various memory and the HDD.
Failing to plan is planning to fail!!!
Yeah, noticed that when I was in there the other day looking for things. HDD & Memory all passed.
I'm 99% sure the MFPC board is the issue. I'm just waiting on feedback from Toshiba before I order
a replacement at this point.
Originally Posted by mojorolla
Sounds like a read/write problem for the print memory. You can go into SIM mode and perform a read/write test for the various memory and the HDD.
Go to the machine screen. There used to be a setting on the old MXM850 Hercules 1 that would disable printing, and turns off if you did a factory reset. I don't know specifically where but if you go to the machine and check under printer/nic settings, it was literally a tickbox that you had to check in order to get it to print. I don't have one here to check, but it is worth taking a look through the menus. The menu wasn't there on web browser, only on the screen.
Went through the entire network settings menu, didn't find anything though.
Replaced the MFPC board...still no go. I think we are to the point to have the manufacturer
come down and just haul it off and give us another one. I don't like sending out machines that
might have ghosts in them.
Long shot. The only thing that came to mind was SIM 26-38, B which will disable printing when the fuser web has ended. Try setting B to 0.
Perhaps the 'web end' has triggered somehow but I would think it would indicate that on the display.
The tickbox isn't in the NIC page. Try system settings>print settings> are there any tickboxes within any menus in there?
After a bit of hunting down, this is what we had preventing printing before.
Make sure NIC is enabled in this setting. If it is disabled, you can still web browse but printing via nic will not work. Pointless setting that will ruin your day
Screenshot 2021-02-22 210331.jpg
I un-checked the Enable Network Port and was still able to navigate the web page. Print jobs would not print. This is on a MX-6240. Grasping at straws.
System Settings
Printer Settings
Interface Settings
ENP.jpg
Reply With Quote
Bookmarks