This isn't urgent since it's been fixed now. Some insight would be appreciated of what you think might be going on. The original person working on this replaced the fuser for h5-01 and couldn't clear the code. I was called there and after messing with it for awhile found the page was always curling up below the 2nd transfer. All the sensors were responding in the sim test. It seemed to me the 1st transfer wasn't quite right. It had colors on it but they looked like it was stopping. When it was taken out, the gear wasn't cracked and it was turning freely by hand. After awhile I realized they ordered the wrong fuser which was causing the weird codes popping up. I got the correct fuser in there and put in a 1st transfer from a different machine. Then it started working right away.
My question is what am I missing when looking right at it ? It seems like it should be functioning when it's out, but not in the machine. If the machine had a drive problem, how would a different tbu work ? As I said, it's not urgent, but it would be nice to know if it happens again.
Bookmarks