Results 1 to 5 of 5
  1. #1
    Trusted Tech 50+ Posts
    MX3060 Printer Calibration.


    Join Date
    Feb 2011
    Location
    Newry
    Posts
    51
    Rep Power
    24

    MX3060 Printer Calibration.

    Hope someone can shed some light on this one.

    After running calibration 46-74 - copy calibration is fine but on the print calibration the printed the adjusted patch is all washed out. (The target sheet with printer calibration wrote on it is fine).

    Have updated the FW, reset to factory settings, cleared the 67 settings, checked 63-11.

    Any ideas anyone

  2. #2
    Service Manager 1,000+ Posts
    MX3060 Printer Calibration.

    copiertec's Avatar
    Join Date
    Jan 2016
    Location
    Centereach, L.I. New York
    Posts
    1,684
    Rep Power
    71

    Re: MX3060 Printer Calibration.

    Have you performed all the proper calibrations besides the 46-74?

  3. #3
    Service Manager 1,000+ Posts bilyahn's Avatar
    Join Date
    Dec 2006
    Location
    Quincy, CA
    Posts
    1,344
    Rep Power
    49

    Re: MX3060 Printer Calibration.

    Haven't seen this but 2 things you might try.

    1. Auto calibration in System settings to see if you get the same results

    2. Try doing the printer calibration separate using sim 67-24

    Good luck

    Bil

  4. #4
    Technician
    Join Date
    Sep 2021
    Location
    Alaska
    Posts
    12
    Rep Power
    3

    Re: MX3060 Printer Calibration.

    Hello, you can use the sim 50-22 to calibrate the laser adjustment and then do the pattern calibration, if the laser is misplaced or moved it will not adjust well, adjust OPC drum phase, and check that it is within the parameters.

  5. #5
    Trusted Tech 50+ Posts
    MX3060 Printer Calibration.


    Join Date
    Feb 2011
    Location
    Newry
    Posts
    51
    Rep Power
    24

    Re: MX3060 Printer Calibration.

    UPDATE

    Just for info it was only the print calibration that was the issue, The copy calibration was fine.

    After trying numerous resets calibrations, firmware in CN mode etc,

    We copied the SSD and EEPROM data from another machine and imported it - Ran the full calibration again and all is fine.

    Thanks for inputs -

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Get the Android App
click or scan for the Copytechnet Mobile App

-= -= -= -= -=


IDrive Remote Backup

Lunarpages Internet Solutions

Advertise on Copytechnet

Your Link Here