You would need to buy it from a Sharp Dealer.
I have a clean image of a MX-3110N SD card I could send to you. Copy that to a new Sd card. Buy a good quality 16GB SD card from either Amazon or eBay. I think you only need 2G but we use 16GB across the board.
Here is an image file for a MX2610 which I believe is the same image file. Use HDD raw copy tool to image it onto the SD card.
https://www.dropbox.com/s/ii31m95mws...610N.imgc?dl=0
Send me your mailing address and I will send you one. If it works $15 plus postage.
Back again after a very helpful and kind Tech here tried to assist - but unfortunately no success.
He provided a known and tested SD card to me vial mail since i could not get the Raw Copy Tool to work.
However that did not resolve the problem.
I then replaced the HDD with a new Western Digital 160GB but no success with that either. (He sent me the firmware in case it was needed)
He has suggested I go back to this forum to get any other advice.
Previously Iky1978, a Tech here, recommended the Power Supply could be the culprit.
I'm just asking before I do that - does this look like the most likely route to anyone else as well? Thanks again to all.
As a recap - on main poser on I get power enough to move the scanner and run the fans - and the sleep light is on, but no display and no button on the display does anything. Will not print anything either - tried that.
Bookmarks