Part # ?

[nathansipe]

Could someone verify if the fuser unit DUNTW9342DS46 will work on the MX-3070 model? Or what other models it fits. I ordered this fuser awhile back for the MX-5050V series, I believe, and now I can't even find that part number in the manuals. Maybe my mind is burnt out. I assume Sharp made a change at some point so fusers were more compatible across their series.

I put the DUNTW9342DS11 and DUNTW9342DS15 straight from the parts guide for the 3070 in the TD Synnex Sharp site for the MX-3070 and Sharp says not available. I have the latest parts guide.

On the ordering site, it shows the DUNTW9342DS46 is the same as the DS26, but I'm assuming that's the part number for the 607FU1. It confuses me even more really.


I've been ordering Sharp for years, so I feel really dumb.

Thanks.

[bilyahn]

Re: Part # ?

According to Hytec this is an MX-607FU1 for the 5050/5070 series. Will not work in 3070 pin and connectors are different.

Good Luck

Bil

[mloudy]

Re: Part # ?

Somewhere on the Sharp service site I think there is an Excel part sub list. Before TD parts would auto sub when ordered. Now when you put in a part number that has a sub it will just come back as unavailable or no match. Stupid.

[Hansen88]

Re: Part # ?

If you look on precision roller, they also show any compatable models.

[mloudy]

Re: Part # ?

My info says the MX-407FU1 or DUNTW9342DS51 is the fuser for the MX-3070.

The Sharp Sub List updates the DS15 to a DS51

Ordering the MX-407FU1 from Sharp would be the cheaper option.

[nathansipe]

Re: Part # ?

Yes, Precision Roller shows it as 407FU1 and DS15.

mloudy, thanks for that info. It's showing up with that DS51 number. Any idea where that Excel sheet is located? I'm assuming somewhere in Sharp-Start IDNC with the manuals and not the TD Synnex site.

[mloudy]

Re: Part # ?

Yes, Precision Roller shows it as 407FU1 and DS15.

mloudy, thanks for that info. It's showing up with that DS51 number. Any idea where that Excel sheet is located? I'm assuming somewhere in Sharp-Start IDNC with the manuals and not the TD Synnex site.

It used to be on the Home page I think. I searched for it this morning on IDNC Service and could't find it. The one I have is from 2022.