If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Hi guys, can anyone maybe assist me with a part number for this rear plastic frame inside a Sharp MX-5051 I've looked up and down the parts manual but it doesn't seem to be in here
I have looked for that before. In my Parts Guide it is shown in section V30 with no part#. It is way more than just the rear frame. I am not sure I would even attempt to swap out that frame though.
We bought a used copier and they strapped it so tight to the side of the semi trailer that it cracked that frame at the right rear. It became a rental as I would never sell it.
I had one with 6 months of lease remaining that a tech improperly installed the fuser drive and cracked the frame. We got lucky and were able to use an epoxy to repair it. It lasted the remainder of its lease that way without issue. I was not able to source that frame at the time, nor do I think we could have easily done that repair anyway.
Comment