Ok
Thanks Blackat, y think that to, but there no kind to repair them?
regards
Ok
Thanks Blackat, y think that to, but there no kind to repair them?
regards
Perhaps, but board level repair is beyond my skill level. I'm going to say this one last time: Replace the laser unit.
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
Hi
Blackat, thanks for your help.
Definitely the issue was in the laser unit, but i could fix it
whithout replace for one new.
I disassemble it ,and carefull took off the poligon motor
and found cold welding in own boadr that repaired.
I to also put a little of oil in the came of poligon motor.
And chek to the VR1 contacts and VR1 weld.
Finaly all mounted and works good.
Y hope this description can be util for someone else.
Thanks Blackat, Bill
regards
Bookmarks