mx-2300 44-26 error

[DINGO]

hi
i have a mx 2300 that when i execute the s 44-26 i get a result error k;m;c;y?

can anyone tell me something about?
thanks in advance

[Dark Helmet]

Re: mx-2300 44-26 error

Im guessing the machine can't read the half tone patches on the belt. Have you cleaned and recalibrated the Procon sensors with the jig? Try running 44-2, 44-6, then 44-26 after cleaning and recalibrating with the jig and sim 44-13.

Are solids ok looking when you print?

[mojorolla]

Re: mx-2300 44-26 error

SIM 44-27 to clear the value, then 44-26 to set a new value. 44-13 is used with the jig.

[igi]

Re: mx-2300 44-26 error

Error" message when performing Sim. 44-26 (Forced Execution of Half Tone Image Correction)
Cause:	Half tone image correction is outside of the operating specification. Perform Sim 67-24 (Printer Auto Color Calibration) to bring the machine closer to specification, which should then allow Sim 44-26 to be completed without error. good luck

[DINGO]

Re: mx-2300 44-26 error

Error" message when performing Sim. 44-26 (Forced Execution of Half Tone Image Correction)
Cause:	Half tone image correction is outside of the operating specification. Perform Sim 67-24 (Printer Auto Color Calibration) to bring the machine closer to specification, which should then allow Sim 44-26 to be completed without error. good luck

thanks all.
infortunaly i do not have the calibaration jig, but i do what igi post and now the copier was very good.

regards

[Dark Helmet]

Re: mx-2300 44-26 error

Better order one up!

Jig part#

UKOG-0318FCZZ

[DINGO]

Re: mx-2300 44-26 error

thanks lawrence

[DINGO]

Re: mx-2300 44-26 error

Hi
i have another mx-2300 with the same error, i do the same procedure , but in this case no sucess.
any idea?

i already ordered the jig, and y try perform the 44-13, i hope this fix the error.

thanks friends

[Munter]

Re: mx-2300 44-26 error

Error" message when performing Sim. 44-26 (Forced Execution of Half Tone Image Correction)
Cause:	Half tone image correction is outside of the operating specification. Perform Sim 67-24 (Printer Auto Color Calibration) to bring the machine closer to specification, which should then allow Sim 44-26 to be completed without error. good luck

Necroposting to say this helped me out of a situation with a non-compliant copier. There are still some of these relics out there and this advice might apply to other models too.