hi
i have a mx 2300 that when i execute the s 44-26 i get a result error k;m;c;y?
can anyone tell me something about?
thanks in advance
hi
i have a mx 2300 that when i execute the s 44-26 i get a result error k;m;c;y?
can anyone tell me something about?
thanks in advance
Im guessing the machine can't read the half tone patches on the belt. Have you cleaned and recalibrated the Procon sensors with the jig? Try running 44-2, 44-6, then 44-26 after cleaning and recalibrating with the jig and sim 44-13.
Are solids ok looking when you print?
Last edited by Lawrence; 04-19-2012 at 01:52 PM. Reason: Wrong sim code
Evil will always triumph because good is dumb.
Its all shits and giggles until some body giggles and shits...
SIM 44-27 to clear the value, then 44-26 to set a new value. 44-13 is used with the jig.
Failing to plan is planning to fail!!!
Error" message when performing Sim. 44-26 (Forced Execution of Half Tone Image Correction) Cause: Half tone image correction is outside of the operating specification.
Perform Sim 67-24 (Printer Auto Color Calibration) to bring the machine closer to specification, which should then allow Sim 44-26 to be completed without error.
good luck
Better order one up!
Jig part#
UKOG-0318FCZZ
Evil will always triumph because good is dumb.
Its all shits and giggles until some body giggles and shits...
thanks lawrence
Hi
i have another mx-2300 with the same error, i do the same procedure , but in this case no sucess.
any idea?
i already ordered the jig, and y try perform the 44-13, i hope this fix the error.
thanks friends
Bookmarks