Arm 550u

[Donnie]

Machine has around 780k, has stapling finisher, used as a stand alone copier. After it completes each copy job it reboots as it is cycling down. All functions work and it will complete each job, no matter how many sets. Just when it starts to go to standby it acts as if it was powered on/off. Anyone seen this? Thanks.

[bilyahn]

Try unplugging the finisher to see if it still does it. What have you tried so far?

Good luck.

Bil

[Donnie]

I did stop by yesterday, could only stay a few minutes due to prior appointments. I removed the finisher, cleaned corona, checked the operation. That's it so far. Thanks.

[lky1978]

Machine has around 780k, has stapling finisher, used as a stand alone copier. After it completes each copy job it reboots as it is cycling down. All functions work and it will complete each job, no matter how many sets. Just when it starts to go to standby it acts as if it was powered on/off. Anyone seen this? Thanks.

is it data security kit installed?

[Donnie]

is it data security kit installed?

No, it doesn't have a security kit installed. We have not sold sharp in a few years. With a security kit, does it reboot every time an operation is completed? Thanks.