Dear All ,
My toshiba e studio 207 appering only please wait . I try to reset useing 1+3+* but still same issue .
Dear All ,
My toshiba e studio 207 appering only please wait . I try to reset useing 1+3+* but still same issue .
Do you have GA-1200 scan kit?
If Yes remove it and try machine, if it comes to Ready format CF card.
A tree is known by its fruit, a man by his deeds. A good deed is never lost, he who sows courtesy, reaps friendship, and he who plants kindness gathers love.
Blessed are they who can laugh at themselves, for they shall never cease to be amused.
I don't reply to private messages from end users.
An open heater lamp could cause that. =^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
I don't have any 207's, but since they share most of the parts of the 455/56/57 series, makes sure
if the fuser has been rebuilt, that the connections and lamps were put back in the proper place.
I've had techs switch the connections around, and even if they have changed the lamps to make it
"impossible" to do that, Murphy's Law ya know...
Cause are below
1. CIS unit
2.20 pin flexible flat cable
3.SRAM
4.logic board
Bookmarks