Thanks: 0
Likes: 0
Dislikes: 0
Toshiba 2830c - Display/Op Panel blank.
Toshiba eStudio 2830c
Powers up, Lights in right side upper corner of panel light up, but no display.
Worked on Tosh for years but have been away for some time doing Canons. Do these op panels just go bad?
Thanks for your help folks!
Pete in Prescott, AZ
USMC 70-75
check HDD or RAM stick on controller,Originally Posted by Pete from Prescott
should be rebuild firmware if the HDD fault.
good luck.
Re: Toshiba 2830c - Display/Op Panel blank.
Not sure I understand...
..."should be rebuild firmware if the HDD fault".
reload firmware
I just changed a HDD on one of these last week. It was an 80GB SATA Drive.
That being said, even if the machine is in perfect condition it's hard to justify spending any money on it. It's been obsolete for over 5 years. The last remaining machines are just limping along until they die.
=^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
Reply With Quote
Bookmarks