I replaced Thermistor check fuse and Lamps OK Machine come on, goes to warm up and back to C410. Fuser unit not hot.
I replaced Thermistor check fuse and Lamps OK Machine come on, goes to warm up and back to C410. Fuser unit not hot.
This was an odd one:
Tray #1 shows "Load Paper" when full. C130 is stored, on eS-355SE.
Logic board does not engage the lift motor for a long enough time.
Replace logic board (6LH60482300). Reset C410 error in 08-400. Run 08-4582 to copy EEPROM data to SRAM. Reset maintenance modes 6S-2 (all were at 99999999).
Logic PWB and wiped SRAM. What are the chances of that? Personally I wouldn't spend more than $50 to fix this machine. =^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
Bookmarks