Thanks: 
Likes: 
Dislikes: Hi i have te Toshiba estudio 257 and the machine is completely dead nothing on display no error codes no fan moving only light green power light.If someone had experience with this problem i hope gona help me
Hi i have te Toshiba estudio 257 and the machine is completely dead nothing on display no error codes no fan moving only light green power light.If someone had experience with this problem i hope gona help me
Couple things...pull the fuser out, see if it will power up.
After that, disconnect any ribbon cables from the system to the logic, along
with the "power" cable on the logic (it's usually the larger wires, red, blue, white, black).
See if it will try to power up.
Also, double check the low voltage power supply for any blown fuses. Check them with
a meter. The glass fuses sometimes will pop, right under the metal cap and the fuse wire
will look ok.
board SYSOriginally Posted by briko
I was sent out to install the SECOND power supply in two days on a LoireX. I discovered a blown fuse on the power supply. I changed out the fuse and powered up. While it was powering up there was a HUGE SPARKFEST from the fuser. Apparently, the last person to rebuild the fuser hadn't quite got the "C" clip completely onto the roller, and it was shorting out the lamps. I installed my last fuse, and returned with the second new power supply unopened. =^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
I disconect everything from the system board I disconnect the fuser same situation dead machine only green power ligt
I think maybe is power supply im gona order and i chachkit maybe gona power on thanks a lot
Sent from my iPhone using Tapatalk
You meen system board are you have expiriance with this problem
Sent from my iPhone using Tapatalk
Hated those things. If it popped off just right, those clips would weld themselves to the lamps.
Don't you know it! I just got lucky.
It was fuse F101, 20A (15 amp holds, if it's not a dead short). I would definitely check that first. =^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
Reply With Quote
Bookmarks