Docucolor 252 error 042-436

**jlgreen19** · 02-26-2016

Need help. We keep getting error 042-326. Tried to reset with 701-105 chain but the machine says it can't be overridden. The value in the chain has 208. We've installed a new belt but the error still comes up. Any suggestions?

Sent from my SCH-R530C using Tapatalk

**InterfaceP** · 02-26-2016

Your Fault code is 042-326 and the NVM you need to change is 741-105. But if you dont take corrective action, it will come back and/or you will damage the IBT belt.

This is a video I shot several years ago.

https://youtu.be/nug0CbfX-no

Good luck!

**Jake2o** · 02-26-2016

Have you taken the sticky paper cover off the reflective strip on the underside of the belt on the inboard side.
If not the error will keep occurring.
check this before you do what the guy above me said to do, or you will go round in circles forever.

**jlgreen19** · 02-26-2016

Omg, no I didn't. Thanks. I just reset/initialized everything, cleaned the sensors and everything worked after that.

Sent from my SCH-R530C using Tapatalk

**InterfaceP** · 02-26-2016

Originally Posted by Jake2o

Have you taken the sticky paper cover off the reflective strip on the underside of the belt on the inboard side.
If not the error will keep occurring.
check this before you do what the guy above me said to do, or you will go round in circles forever.

With respect, please do not do this. That coating is made of Teflon, and prevents the reflective patch from getting dirty. Removing it will cause more headaches than you want.

**Jake2o** · 02-26-2016

Originally Posted by InterfaceP

With respect, please do not do this. That coating is made of Teflon, and prevents the reflective patch from getting dirty. Removing it will cause more headaches than you want.

But on IBT belts that i have got in the past it is a piece of paper that covers the reflective patch thereby making it not a reflective patch and you get a 042-326 instantly on powering up the machine.
So although it will stop the patch from getting dirty it will also stop it being a reflective patch.
I've also had belts that have nothing covering the reflective patch, ones with the teflon coating patch that work fine and others with the teflon coating that do not work properly.
So I suppose it's a case of work with what you have.

**Apouthe Donald** · 02-27-2016

hello dear friend I have an M24 xerox and I dragged two messages that prevent the copying draw. the messages are: TRANSFER BELT CLEAR (replace now) and SECOND BIAS TRANSFER ROLL (replace now). I replaced both Elements but nothing changes.

**Jake2o** · 02-27-2016

Originally Posted by Apouthe Donald

hello dear friend I have an M24 xerox and I dragged two messages that prevent the copying draw. the messages are: TRANSFER BELT CLEAR (replace now) and SECOND BIAS TRANSFER ROLL (replace now). I replaced both Elements but nothing changes.

Did you also re-set the NVM to tell the machine that a new one has been installed