Xerox C70

[Piper]

Hello All,

Xerox Color C70 is giving me 062-330. Anyone with the EDOC?

Will appreciate your help.

[jhalfhide]

Hello All,

Xerox Color C70 is giving me 062-330. Anyone with the EDOC?

Will appreciate your help.

Check that and post the resulting 2 digit code. If no faults found, replace following parts in sequence: DARTS2 PWB > ESS PWB



Sent from my iPhone using Tapatalk

[Piper]

Thanks for that. I will execute that and get back. But I am willing to pay for the C70 EDOC Installation Software.

[Copy70]

Check that and post the resulting 2 digit code. If no faults found, replace following parts in sequence: DARTS2 PWB > ESS PWB



Sent from my iPhone using Tapatalk

Hello i am having same problem with my xerox c60. The steps mentioned here are too complicated for me to execute and understand them properly. Is there a step to step guide to go through this process ?

Any help will be greatly appreciated.

Kind Regards

Hameed

[WIWA]

Hello i am having same problem with my xerox c60. The steps mentioned here are too complicated for me to execute and understand them properly. Is there a step to step guide to go through this process ?

Any help will be greatly appreciated.

Kind Regards

Hameed

Hi,
had the same problem 715-030 done result display 1100 any information you can bring will be appreciated

[adriansto]

Hi,
had the same problem 715-030 done result display 1100 any information you can bring will be appreciated

The connection to the DADF is short-circuited and breaks the DARTS2 PWB.
Replace DCDC-DARTS cable and CIS DC/DC CONVERT PWB or even DARTS2 PWB.

[WIWA]

The connection to the DADF is short-circuited and breaks the DARTS2 PWB.
Replace DCDC-DARTS cable and CIS DC/DC CONVERT PWB or even DARTS2 PWB.

Just to thanks will check later post again

[Rusty.Harris]

Had an intermitten problem like this on a C60. When we looked into it, the connector from the doc feed to the back of the machine
was bent. After tearing it apart, you could see physical damage to the socket. Replaced the socket and the problem went away.

[WIWA]

Had an intermitten problem like this on a C60. When we looked into it, the connector from the doc feed to the back of the machine
was bent. After tearing it apart, you could see physical damage to the socket. Replaced the socket and the problem went away.

Thanks for the hint will check later then post results

Thanks in advance