Hi,
Does anyone have DCP 700/i System Software V3.7MN, ASIA PACIFIC Region (PinotAP) ???
SYSTEM : 5.14.0
CONTROLLER : 1.211.7
IOT : 54.58.0
Thanks
Hi,
Does anyone have DCP 700/i System Software V3.7MN, ASIA PACIFIC Region (PinotAP) ???
SYSTEM : 5.14.0
CONTROLLER : 1.211.7
IOT : 54.58.0
Thanks
Thx for your mail and info my friend. but its not hardware problem as clue, its software issue since I was tried to update firmware with diferrent region.
The machine was fine before. its DCP700Press Asia Pacific Region. its Australia territory.
and its 220volt with fiery Bundled.
If anyone have experience with 700Press here pls, can share the experiances here or PM me.
I am looking Asia Pasific region Firmware, especially from Australia.
Pls let me know or you can PM me
Regards
Is the software that "adriansto" not Asia Pacific?
Are you certain your issue is software related?
Is the software currently installed Asia and is the 700DCP originally sold in Asia?
1. No its not. it is XC (North America) and works on XE (Europe). I have checked file bin, the header was PINOUTXC, since my Machine is PINOUTAP
you can check the NVM 700-421 thrugh 700-427 (check on your machine).
2. Yes its sofware related for me, and its my fould. becouse it was error 016-742 (Cek ON RAP...). so i decided to reversing the BIN file, then i start to change some offset on it, then the process update begun with no problem till finish. but evrytime i start to do copy or print in 1 page, always getting error 124-372. and the other problem is the UI button function is changed (Machine status to All Service).
3. YES........and mine is from australia (PINOUTAP).
So i have plan to dump the EEPROM. hope i will found something in it. till there is an angel here offering me Asia Pacific Firmware.
Regrads
Bookmarks