xerox 700 045-360

[lion_heart]

Good day, hope all is well, seem to be getting this 045-360 error code of my 700 a lot, running external Fiery, I restored my fiery server, hoping that was the cause but same issue. and the RAP gives such a vague description of the error code. any help would be appreciated.

[InterfaceP]

Do you have a External or Bustled Fiery and do you have another of either?

[lion_heart]

Do you have a External or Bustled Fiery and do you have another of either?

This machine is External Fiery, I do have an integrated as a backup, and my creo for next machine went down waiting motherboard for that this week, so would have Creo also

[Detonation]

045-360 is related to the ROS (laser unit). Could be the flat cables (most likely), or laser M,Y or MCU.

[CopierTechofOmens]

• Reseat the interface cable between the DFE and the IOT
  
• Refer to the latest Software Release Notes to ensure that the latest software level located in the software matrix is loaded in the machine
  
• Reseat the VSEL PWB into the Backplane PWB
  
• On Fiery Bustled or EX700 Controlers ensure that the interface PWB is P/N 116N00264 or newer. Replace as required
  
• On FFPS Controllers ensure that the interface cable is the 3M Cable with metal connectors (117K44230). Tighten the connectors with a screw driver.
  
• On FFPS Controllers ensure that the XIMM PWB is 960K51691 or newer
  
• Check that the flat cables are securely connected to the YM ROS and the MCU PWB
  
• Install Tag 3 VESL PWB
  
• Replace the Flat Cable
  
  
• Replace the YM ROS
  
  
• Replace the MCU PWB