Xerox C75

[cpress]

Continuing saga again 061-340 code, replaced c,k ros unit same thing again. Flat cables maybe? Interlock switch seems to be ok.

[cpress]

It’s showing the 061-319 code also....

[InterfaceP]

Try replacing the K Drum first, but while you have it out check to see if the earth pad is there. Its a small pad to the rear and left. It should be visible when you remove the drum.

[cpress]

Try replacing the K Drum first, but while you have it out check to see if the earth pad is there. Its a small pad to the rear and left. It should be visible when you remove the drum.

Put a new one in, cleaned the pad also

[Detonation]

Flat cables are usually the problem, plus they are super tricky to re-attach as well. MCU PWB would be next up.

[EAHG]

Flat Cables. make sure its seated properly after replacing and take extra caution when returning it back as the flat cables easily comes off or loose contact when repositioning, its very tricky.

[elsab]

Flat Cables. make sure its seated properly after replacing and take extra caution when returning it back as the flat cables easily comes off or loose contact when repositioning, its very tricky.

Might be a problem with front cover interlock or with Xero/Deve Drawer assy connector loose contact. It happens on to previous model similar engine with C75.