Hi all, I have this error and have confirmed that the silver position mark is there and clean. The problem is I'm not sure where to begin finding the sensor for it or how to remove the ITB. Thanks in advance, Scott.
Hi all, I have this error and have confirmed that the silver position mark is there and clean. The problem is I'm not sure where to begin finding the sensor for it or how to remove the ITB. Thanks in advance, Scott.
Found the eureka Tec Tip about the IBT Belt drive roll bearing wich is kept in place by a simple rather thin metal plate wich can be deformed sometimes. This causes squeeky noise and can cause a bad /loose contact between drive roll and drive dock at the backside in the machine. We carefully pulled the metal back to its position to reduce / remove the free space. We also decided to replace the 2nd BTR Roller since its far from beeing good and may cause problems with the new IBT Belt unit.
Bookmarks