The fuser work fine, where i find the nvm code for set the transfer toner?
The fuser work fine, where i find the nvm code for set the transfer toner?
Sorry dude, the ghosting procedure does not work, I partially solved the problem with a smaller format and passing the sheets without printing first...
You can set gloss mode on in printer driver.
Or set fuser NVM's to half latch.
Did you run max setup already, as Adrian suggested?
Max setup does not have anything with fuser.
This is well known problem for c560 and dcp700 machines when customer use kunstdruck paper.
There is option for gloss mode in printer driver which customer can use.
Second solution is to set some fuser NVM's which adjust pressure in fuser.
It's right maxsetup do not have anything with fuser but with amount of toner on ibt and finally on paper.
I think there is too much toner on paper and the fusing time is too short to melt and embedded in paper whole amount of. toner.
So, you can try to reduce the amount of toner using maxsetup procedure.
Bookmarks