I did two prints after changing my magenta drum unit and now I'm getting this error code 061-319
I checked its saying something about fuser or fuser sensor.but I don't know what to do.
Sent from my SM-G955F using Tapatalk
I did two prints after changing my magenta drum unit and now I'm getting this error code 061-319
I checked its saying something about fuser or fuser sensor.but I don't know what to do.
Sent from my SM-G955F using Tapatalk
If it says 'something' about the fuser that's the most logical place to start. Have you checked to make sure the fuser is seated\connected properly or that there isn't an obstruction in front of the sensor? Does the drum look damaged or do any of the connections look dirty\faulty? Did you have to remove and replace the fuser to access the drum? (Sorry not familiar with this particular machine) Have you checked\set any service modes or system settings that may need adjusted or updated with new component installation? If it took a couple prints it could just be coincidental but I'd put a dollar on obstruction on the sensor, might help if you posted the actual message word for word. I and many others might not have Xerox documentation on hand.
The 319 when k checked further seems to be something with the drums perhaps the black on I'm not sure.
I did have to replace the OPC on the magenta drum but I'm not sure if that is the issue. Because I gone from getting 061-319 to 061-340 and that error I've been unable to get by. The documentation is saying some black laser. So I'm wondering if it's dirty though I've seen it really dirty and never had an issue. I'll try starting the machine with no drums inside.
I had first taken out the fuser as well and replaced with another but was still getting the 319 error.
Sent from my SM-G955F using Tapatalk
Bookmarks