Originally Posted by
Sn0wlink
I'm currently on holiday at the moment, so I do not have access to a machine to run tests on. So forgive the potential inaccuracy's of this information.
I believe the operator cannot change registration settings as this a automated setup. I think the registration settings in service rep menu is for the page alignment not colour registration.
Some of the most common causes are:
- Dusty fuser encoder sensors (try carefully vacuuming the assembly and running tests, do not use an air line).
- Dirty MOB sensor window and / or laser windows.
- 2 BTR units (Rare, but sometimes that's been the cause)
My guess is to check the MOB / ATC assembly.
Sorry I can't be more specific as its all from memory. Hope this helps.
Bookmarks