Good day, we keep getting this error, we change the C/K Ros laser and then we started getting this after a few test runs. Not sure what exactly. It says the cable but is that really?
Sent from my SM-G955F using Tapatalk
Good day, we keep getting this error, we change the C/K Ros laser and then we started getting this after a few test runs. Not sure what exactly. It says the cable but is that really?
Sent from my SM-G955F using Tapatalk
It says short failure black, I'm not familiar with these machine's but I would assume that has something to do with the (K) and sounds like it's describing an electrical issue... (maybe?) I would start prodding everything in that sequence with a multi meter if that's the case.... Actually what I would probably do is post here lol... I don't know that I have much else to offer on this one. Good luck brother.
Thanks the tech will most likely pass back. He installed the new laser unit yesterday, and it occurred yesterday, then he came back today and after he left it came back up.
He says it's probably the cable but feel maybe it can be a drum cause first I though one the drums jammed because I had to change the film on the developer dover so thought there was a jam. Will give feedback here on what happens.
Sent from my SM-G955F using Tapatalk
You can try also to check the front cover interlock. Might be one of the cause. The flat cable also.
Hope this helps
Sent from my EML-L29 using Tapatalk
I have faced similar complaint with xerox 550...... rectified after replacing Black drum unit
Sent from my Nokia 5.3 using Tapatalk
Check your ribbon cables to the ros (lazer) unit.
Bookmarks