Morning all,
Can anyone help with this please?
I'm unable to save any settings in the photo attached, and I'm getting the error above.
Would this be the ESS PWB?
Many thanks
Morning all,
Can anyone help with this please?
I'm unable to save any settings in the photo attached, and I'm getting the error above.
Would this be the ESS PWB?
Many thanks
Those are not correct settings.
Are you connecting to an EFI Fiery? If so, just set everything to auto and change to 1000 full duplex
Sent from my LYA-L09 using Tapatalk
I'd try an NVM initialisation as it should revert to factory IP config
Sent from my LYA-L09 using Tapatalk
Did you log in as an administrator?
possibly that's why you can't modify the parameters
Hi fatfingers73,
It's evident that the Fiery and machine network settings have been changed for the customer to use the native scan to folder features and not the Fiery Remote Scan. The machine and Fiery would normally be connected via crossover cable. The settings on the machine interface would be set to DHCP and the IP address would be 100.100.100.101. Also the IP address on the Fiery scan interface would be either 100.100.100.100 or 100.100.100.102. If this comms is disrupted by any changes in the network settings, the two devices can't communicate to each other and this isn't critical. All that happens is that tray and consumables information may not get to Command Workstation.
Hope this helps
fugglefeet
Bookmarks