Dislikes:
0
-
Versant 280 Fiery
I have the Fiery hooked up to machine but how do you add the fiery application or Icon to the machines panel ?
-
Re: Versant 280 Fiery
Reseat the black HDMI-cables from the Fiery to the IOT. The cable for the yellow channel is used as a communication cable between Fiery and IOT, if this cable isn't connect properly, the Fiery will reboot after a short while
-
Re: Versant 280 Fiery
I double checked the 2 cables, both are good and going from the Fiery to the proper ports on machine, i can print to the fiery but it still won't load the fiery Application on the machine op panel
-
Re: Versant 280 Fiery
Crossover cable between fiery and machine.
-
Re: Versant 280 Fiery
Definitely connected otherwise how could I print to the Fiery and it prints out a Fiery config page every time I reboot
-
Re: Versant 280 Fiery
Not cable between PC and fiery.
You must have crossover cable between fiery an versant 280 to be able to run fiery application on machine.
-
Re: Versant 280 Fiery
Yes grey Gigabit cable is hooked up between fiery and machine.
-
Re: Versant 280 Fiery
Set machine ip address to 100.100.100.101
Subnet 255.255.252.0
Gateway 100.100.100.102
Dns 100.100.100.102
-
Re: Versant 280 Fiery
I’m pretty sure that what it is since it looks like it set that automatically with DHCP but I’ll verify on Monday. So the Fiery application should add itself automatically on the panel of the Versant you don’t have to add it yourself?
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks