Migrate from Fiery to Postscript - Color 550

[XEROX_1111_TEC]

I people

I need help with a color 560 that was with an Efi Fiery and now the future client will only have Postscript

I´ve already removed the graphics fiery card from the printer and installed the postscript

When I try to print, the printer reports or try to do a copy, I get this code - 045-361

Steps made after:

- all nvm reset except sys-sistem
- tried with a new hard drive and fresh software

Nothing worked

I think I need to see any nvm chain but I do not know witch one

In the end, i´ve installed again the fiery and the printer worked fine.

I really need this printer only with postscript

[xcopytech]

If you removed VSEL pwb from machine then you should replace it with jumper pwb.
You can not copy or print on c550 without jumper or vsel pwb

[Caffeine]

I really need this printer only with postscript

As xcopytech said, just leave the VSEL pwb in there, assuming you don't have the jumper pwb, which can be hard to get. It can run without a Fiery attached, using Postscript on the built in green controller, even while the VSEL is still installed.

[XEROX_1111_TEC]

As xcopytech said, just leave the VSEL pwb in there, assuming you don't have the jumper pwb, which can be hard to get. It can run without a Fiery attached, using Postscript on the built in green controller, even while the VSEL is still installed.

Thanks

I will try that and post what result do I get

[XEROX_1111_TEC]

UPDATE

Your tips were follow and the problem was detected. The postscript pwa contacts were not totally clean so that was generating that error. After cleaning the contacts and reinstalled the the VSEL pwb it worked fine.

Thanks a lot for your help.

Keep safe and thanks once more.