Thanks:
0
Likes:
0
Dislikes:
0
-
Senior Tech
100+ Posts
- Rep Power
- 25
Altalink B8055
Setting registration for prints is good, on the glass is also good. When I use the doc feeder the lead edge is off. I ran DC608, 6 sheets SEF, exit, reboot, and it is still off by 1/5". I tried it several times, the 6 sheets, power off/on, still off.
On older models you could set it using the NVM. Does anyone know these values?
Any help is appreciated.
Mike
-
Re: Altalink B8055
Make adj5 as manual says and after that adj60 all steps in order.
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks