rysiulg
rysiulg
Technician
Last Activity: 3 weeks ago
Joined: 12-29-2014
Location: Poland
-
my internet provider had planned services and for few last hours they cut internet. now is working;€... -
so this is weird situation…;( if nothing is visible like some obstructirs on paper path and e+ goes smooth than it also could pe programm error....Leave a comment:
-
Can someone share this manual for Canon TM300 also parts catalog would be nice? service@marm.pl...Leave a comment:
-
What do you need?Leave a comment:
-
Yes, but robin and portos isn't only available to download on official sites
They only offer to view Service manuals without service mode. ...Leave a comment:
-
Broken gear 1x27 1060011834 (you can use also 0002977057 from 7051 which is all from plastic and works longer without breaks)
it also can be from...Leave a comment:
-
It's dirty charging unit and dirty printhead...
Leave a comment:
-
Sorry but you're wrong. not for this model. For Plotwave 300 and 350 there isn't SAM key access -there is USB2Ethernet adapter with ip 134.188.254.100...Leave a comment:
-
Toner in oce is controlled by toner concentration sensor in developing unit. Toner hoper only have toner end sensor. Very often after service and make...Leave a comment:
-
Attached pdf describes how remove top, left, right covers and scanner -but it is needed to remove back cover of scanner guide -scanner itself can be left...Leave a comment:
-
Very dirty
Window cleaner or soft water is best to clean wires -Grid Wires from top and bottom, case inside corona and charge corona itself ;...Leave a comment:
-
what kind of jamming?Leave a comment:
-
Oce to install controller need usb stick -so i think you have it -latest is 1.6.2 (i good remember).
At first start it check that this is controller,...Leave a comment:
-
it will need more investigation. It could be stepper motor for roll 1 -machine cuts with error or just leave couple of inches paper without cut? -if first...Leave a comment:
-
Yes you can. TDS uses B5 developer previously, but oce changed few years ago and there is one developer for all oce digital printers till 7m/min -so also...Leave a comment:
-
So errors is timout during bootup and none of consumables (drum, developer, charge etc has nothing to do here -they even don't tested by machine control...Leave a comment:
-
Check area under cleaning blade between blade and lower seal -even it is goot to bent to drum side this lower seal -it is very likely that seal is a little...Leave a comment:
No activity results to display
Leave a comment: