22 results in 0.0218 seconds.
-
replace ssd board konica c654
i replaced the ssd board of konica c654, and now i need firmware that can reset it, i hope someone can provide me -
color registration error c654
We have repeatedly had this same failure, in different c654 machines, without a solution...We have followed the normal course, of discarding, with another... -
help identify part, c654 (part number)
please, i need the part number of the actuator of the sensors that are entering the fuser of a KM c654.
that piece falls apart practically impossible... -
-
c654 and c650 finisher output tray going to the floor.
This applies to the FS608 (c650) the FS535 (for c654 ... if recall model correctly).
So basically the sensor for the output tray paper full... -
what models from 4 series correspond to minolta c452
Hello, I have 2 minolta c452 and wanted to buy a new one to rebuild both but the seller only keeps 4 - series at stock so I was wondering if parts from... -
C654 network port issue.
Hi everyone,
So I got a c654 whose network port doesn't light up at all. I've changed the cable and plug it to a different port, no changes.... -
Konica Minolta C654 Misfeed 72-21
Konica Minolta C654 getting Misfeed 72-21. When paper (A4 SEF) exit from the finisher tray 2. From left side doesn't come out smoothly so start getting... -
-
-
C654 image shift
Hi all
I got a C654 the has a image shift issue when printing on thick stock (300gsm so in spec).
Fuser is fine, changed main drive unit... -
Konica Minolta C654 PJ in Bridging Unit
Getting paper jam in Konica Minolta c654 when it enters the bridging unit. From Manual/By Pass Tray (Portrait only) It works fine.
Please... -
c654e J99-01
luckily haven't spent too much time on this issue. But I have a J99-01 jam coming out of tray 3. I've read a few threads on this lovely forum and followed... -
Konica BH C654 FK-511 installation issue
Tried to install the Fax Kit on a BH C654. Followed install procedure.
SW2 on fax control board set to Line 1
Mounted in lower socket
... -
KM C654 & IC-414 - communication
Hi,
My KM C654 won't communicate with Fiery IC-414 (restored from dead disk) because the Image Controller Setting was set to "Others...Last edited by bmt_hr; 09-15-2018, 11:43 AM.
