Having toner deposits build up on primary grid after two weeks causing faint line.
Konica C554e.Has any one seen this problem?I can clean...
302 results in 0.0984 seconds.
-
faint horizontal line across page
-
Xerox 5875 Charger Grid Problem
Hi,
I am new to this forum.
recently i have a problem with my 5875 machine having big black stripe on middle of the page. clean the charger... -
5005ac waste toner
Have a 5005ac giving a false waste toner message. Sensor(s36) read bad in test mode. Replaced sensor to no effect. Can't find it on the wiring diagram.... -
Kyocera ADF tray: size sensing
I've had 2 calls lately where the ADF tray was reading the incorrect size paper.
When I took apart the tray, there's a electrical grid,... -
grid lines appearing on copies??
Hi guys im new here, I have just acquired a Canon iRC3170 photocopier and it prints an even grid pattern (about 2mm width and 7mm height) on top of what... -
Part Number
I have looked into the Service Manual of Canon IR Adv 6075 and it says there the Primary Grid High Voltage Connector (FM4-1006) and the Pre Transfer High... -
FS-6526
Machine will print and copy in color. When put in U410 it only prints the B/W grid and a blank sheet for the color grid. Anyone seen this before? -
Problem of vertical lines Press C7000
Dear colleagues, I have a c7000p device with vertical lines fault only in the black color, it is already replaced Unit developed (UR), the drum,... -
Rioch aficio 3045 prints a grid
Hi, I have a ricoh aficio 3045 machine printing a grid or just a seccition of a grid, the sqquares on the gird are big like 5 cm in each side, I nkow... -
6550C Color Charge Corona Grid Part #
The parts book lists two numbers , which one is for the color grid ? -
c454e stripping developer
Ok, this one has been driving me nuts.
I have a customer with a c454e with close to a million copies on it. Now the parts life notifications... -
IR2870 subscan magnification misalignment
Hi Everyone,
any of you know the solution of my problem here.
machine IR2870
I Don't know exactly what you call this problem... -
Mita xi8020 c550 code
Hello dear all!
My machine when it's warm up and going round it's turn off suddenly and turn on again three times then give a code "Call for... -
Konica 7145 Drum Installation Issues
Recently I had to remove the drum in order to clean that little sensor on the drum unit. After the cleanup I put the drum back into the unit and ran... -
eStudio 3500c Error Code C970
High voltage transformer abnormaility.
Copier had been running fine in same location for years.
The four things listed in...
