Hello,
Lexmark MX410 came in for repair and the fuser needed to bereplaced. I have had replaced the fuser with the new one, reset it and this...
32 results in 0.0267 seconds.
-
Lexmark MX410 slowing down in print speed after 3 pages
-
Software guy checking in!
Hi everyone! I'm perhaps not the target audience for this forum as I'm more of a software guy than a hardware/technician guy, and more interested in saving... -
dp-7100 question
Hey everyone!
After taking a two year break from the industry, I'm back in action at a Kyocera dealer.
I initially went to... -
sp4510 fuser in a sp3600
anyone know if a sp4510 fuser is compatible with a sp3600. it works fine just jams on duplex only when trying to reverse. i know they have different... -
MPC 5502 adf issues...
Hi again,
This is becoming habitual, twice in a week!!
So, to the collective wisdom of the Ricoh forum, a new problem that... -
Konica Bizhub c458 jamming
Have a bizhub c458 that simplex prints with no problem. However when duplex, paper exits into bridge unit then on way back into reverse assembly jams... -
-
Using bizhub 600 ADU board in bizhub 601
Can I use bizhub 600 board in bizhub 601. I use on in 601 but now paper exit/ reverse gate not working. -
TA8001i Exit rollers running in reverse
Hi all,
Was wondering if anyone out there has had an 8001 exit run in reverse. I have several in a school district that will do this with certain... -
Formax 8902CC Paper Shredder Won't continue running
I am a copier tech that is helping a disabled community with there paper shredder. A formax 8902 CC When you press start it goes in reverse. Then the... -
eS5506ACT "Replace Magenta Toner"
Just delivered. Within minutes of the delivery driver leaving it goes into toner add condition.
I tried clearing the indication a few times,... -
Bizhub 363 DF 621 jams 2 sided originals
Hi Guys,
I have dealing with J66-01, this is for ADF turnover section.
This occurs only on 2-sided copy/scan job. It always jams every single... -
Ricoh MPC305 - broken Guide Plate : Reverse Upper
Can anybody advise if they have found a easy way of replacing Guide Plate : Reverse Upper without stripping the whole scanning unit of the machine first.... -
C402SC APPD1_N jam
Having a APPD1_N jam issue and not to sure what else to try. Machine does have a FN12 installed. Pages jam in the exit unit area with the lead edge going... -
Reverse Duplexing Drive Unit C3330
I have a noise (squeak) duplexing only on a Advanced color 3330 and found a tech pub on the reverse duplexing drive unit causing a noise. I ordered it...Last edited by dan7777; 11-13-2017, 09:15 PM.
