Stopping by to say hello. I'm an end user with a long history of dissecting perfectly good equipment to learn about innards.
...
185 results in 0.1093 seconds.
-
New guy, first post
Hello all!
Stopping by to say hello. I'm an end user with a long history of dissecting perfectly good equipment to learn about innards....
-
C-3350i, squeaking from exit section...
I know this has been posted before, and I read up on that. But this one might need to have the exit section pulled out (not looking forward to it) because... -
Kyocera P2235 smearing and jam
Smearing and often jam at the same position. Paper has left fuser and leading edge is 5 inch or so out of the exit section.
Thanks.
... -
J93-10 Duplex Paper Jamming bizhub c454e
Single side printing is working fine. Duplex printing paper jams at reversal section. It goes to the duplex exit and then solenoid pulls the gate when... -
Bizhub 958 3205 Jamming nightmare
This machine runs for a few months and then starts jamming like crazy. I was over there earlier today and ran approximately 2000 without any issue. Gone -
C4070 Drums
What is the main difference with the DR620K and DR620?
Can the DR620 be used as a K drum unit.
Also can the Du106 and Du105 be used... -
Konica Minolta - C454e
Hi guys,
got a question as customer has asked because his previous Xerox did this function,
so when the user copies/scans an... -
Phaser 7800 Stuck at Booting?
I'm not a big Xerox tech; mostly HP, but, have some experience with them.
This 7800 is stuck on the "booting"(?) screen. After... -
Am I getting old........ or... WHAT?
Got from a wholesaler a BH-C-284e with only 40K on the clock. Prints were coming out with four rows of tiny indentations. One row of dents across feeding... -
Jam 0118 on imagepress C850
I have a case with a delay jam on duplex section on a Imagepress 850.
Counter close to 2 milion.
After replacing all ((the... -
Ricoh MP 3054 Jam Code Won't Clear
Hey all...didn't want to bring a thread back from the grave but I'm having some similar issues that have been discussed but haven't found a solution yet.... -
P3155 jams at fuser exit at exactly same position
Jams occur at every print or somtimes 30 pages or so are ok then jam at every page again.
Paper has already left fuser unit about 10 or 15 cm and... -
Xerox nuvera 288 NVM
Hello! Printing machine Nuvera 288 Xerox. Error 03-3970 low battery nvm. The problem was solved by replacing the new NVM board. After one year, the error... -
konica minolta doc feeder df 624 mylar question
so initially I have been getting quite a few jam code 66-05 which I have learned a ton about today.. so I am in the middle of a situation where my customers... -
c654 low count xbelt skidmark
Basically, this belt has less than 80k on it and it is leaving a very noticeable mark of thick-glossy stocks (not so noticeable on thick matte and hardly...
