20 results in 0.0141 seconds.
-
Konica Minolta C308 fuser unit termostat
I have a Konica Minolta C308 where I decided to rebuild the fuser unit. I have now changed the fuser film that had some marks on it. I have later figuredYou do not have permission to view this gallery.
This gallery has 7 photos. -
Ricoh MPC2050 SC542
I have this service code and have done following:
1. Changed Heating roller thermostat
2. Changed pressure roller thermostat
3. Changed... -
Bizhub Pro 920 - 36 codes cannot resolve
Very annoying problem. 36 codes that vary which ones come up every few days. I go in clean the aux roller (some stuff slightly crusted on the roller)... -
Bizhub 600 Fuser ?
Just wanted some thoughts. It seems that everytime I have to replace the UFR in a 600 or alike model, the UFR is worn towards the front of the machine... -
Ricoh Aficio 1018 error SC544
I got this error on Aficio 1018. Error is SC544, I checked thermistor, thermostat and thermo fuse.
They are ok. Fusing lamp is ok too. When I try... -
Thermostat on Bizhub 164
I have problem with KonicaMinolta BZ 164, need to change Thermostat in fusing unit. But in part manual we must change as a unit. Anyone have a solution... -
sharp ar m276
need help here..
power supply unit middle fuse blow..
but when i disconnect heater lamp connector -> fuse ok...
is it bcouse... -
MP6500/192 Degree Thermostat Fails/SC555
MP6500 - 2 million copies - all thermistors, thermostats and holding brackets updated - all SP warm up values changed per Ricoh.
End thermostat... -
Richo mpc5000 sc582
Ih board error and the real problem is with the ih thermostat. -
error code c411 and c412 help
hi, we have a fuser that keeps giving us a fuser error c411 and c412. i have tried to clear the error in 0,8 mode and it dosent work. the status counter... -
Af MP 161 spf OVERHEAT
Hi.
I have Af MP 161 spf always pop up SC 542 and the fusing unit overheat.I already replaced thermsitor, thermostat and do reset the sc... -
Minolta Di470 C0042 Imagistics IM4720
Have an error code of C0042. Fuser fan motor failure. But, the motor is clearly working. Also was getting a C0510 error. Fuser temp abnormally low. But,... -
MPC 4000 thermastat
Have any of you found a cost effective way to replace this thermostat rather than the entire coil assembly in a MPC4000?
Apparently there is a -
C 430 ( toshİba e-230)
C 430 error gİve.08 400 you entrance often but agaİn no İmprove ..please help frİends -
Open heat cycle error SCX-6322
We replaced the fuser unit and it will only works for 2-4 days. After that the open heat cycle error appears again. We've replaced the fuser unit 4...
