iR5000

[waffu22]

Hi to all the readers

iR5000 machine starts with an error 0004 - 0001. My operator did not turn off the machine and leave it open ( 1 hour ). When i go to on svc mode to clear the error, when i ON the machine, its in WAIT mode.

Any ideas?

Thanks...

[shazza]

Hi,

Check thermistors and lamps H2 Fuser lamp may of blown
(REPLACE FUSER LAMP P/N FH7-4552). Also make sure staple cartride not empty! May sound strange but had same problem on a 7105

Shazza

[trainman6446]

also try cleaning the fuser contacts on the fuser frame assy

[waffu22]

Hi,

Check thermistors and lamps H2 Fuser lamp may of blown
(REPLACE FUSER LAMP P/N FH7-4552). Also make sure staple cartride not empty! May sound strange but had same problem on a 7105

Shazza

I swap the whole unit 1 to other machine and its OK.

I suspected a bad HD.

[smiley]

hi it can be a bad thermistor.try to replce it and clear the error.

[SCREWTAPE]

Check the fixing feeder unit connectors and the ones in the inside rear part of the machine. Make sure that these terminal connectors are making proper contact when you slide it in. Check for jammed packed paper inside of those connectors.

[mrfixit51]

Hi to all the readers

iR5000 machine starts with an error 0004 - 0001. My operator did not turn off the machine and leave it open ( 1 hour ). When i go to on svc mode to clear the error, when i ON the machine, its in WAIT mode.

Any ideas?

Thanks...

I got hung up on the E004 error code, but I agree that your most likely cause of the wait... is a faulty hard drive.

[MrB]

Could be as something as simple as a scrap of paper inside the fixing unit connector
Could be as strange as that
Check both sides of the plug
(On the fixing unit and the 2nd part of the connector inside the device)

[waffu22]

I got hung up on the E004 error code, but I agree that your most likely cause of the wait... is a faulty hard drive.

Your right mrfixit51, its faulty hard drive.


Thanks for the reply guys

[angelntx]

Anyone bother to check the thermoswitch? If the coating gets worn off you will see this code.