I have problem with my IRC4580 when i turned on the main power switch the eror code appeared E004-0101. i tried to clear ERR already but nothing gonna happened. What is more i dont have Service manual. Thanks in advance.
-
-
E004 Fixing unit protection circuit trouble
0101 When there is a short-circuit detection error in the halogen heater (ASIC
detection)
Check the connection of the J114 jack of the AC driver PCB, and replace
the AC driver PCB (triac short).
Replace the Pressure heater.
Replace the Fixing unit.
Replace the DC controller PCB 2 (MAISY).
How many copies have machine.If it ain't broke, don't fix it
A picture is worth a thousand words -
-
You might need a fixing assy. $$$$$$Comment
-
imageRUNNER C5180 / C5180i / C4080 / C4080i / C4580 / C4580i
E004-0101
Error :
E004-0101: Halogen heater is damaged or terminal of heater has poor contact.
Because of damage to the halogen heater (H1) or poor contact of a heater terminal, the error code "E004-0101" was indicated. This error code may be indicated due to a fault in the AC Driver PCB (i.e., triac short), the fixing assembly, and the DC Controller PCB 2 (MAISY). However, before replacing these parts, perform the following procedure.
- E004-0101 can be displayed when there is a short-circuit detection error in the halogen heater (ASIC detection).
1. Detach the terminal on both ends of the halogen heater, and then check to see if the heater has electrical continuity; if there is no electrical continuity, replace the heater with a new one.
2. Check to see if the terminal [A] on both ends of the heater is fixed firmly with a screw. If the screw is loosened, tighten it.
3. If the symptom still occurs, check to see if J114 connector of the AC Driver PCB is disconnected. If disconnected, re-fit it.
FK2-2532-000 Halogen Heater (120V)
FM3-0266-000 DC Controller PCB 2 (MAISY)
FM2-6301-000 AC Driver PCB**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Comment
Comment