i dear i haveing problem in ir7105 finisher not detected. there is no code.
how can i fix this problem plz help me i am to tide.
thanks.
how can i fix this problem plz help me i am to tide.
thanks.
-
-
Re: canon ir7105
The finisher is connected via a coaxial cable with bnc connectors, make sure that it is not directly connected , you need the t-shaped connectors with the termination resistor attached to make it work correctly. Also make sure, that, after first install of finisher the mashine has done its full power down cycle (you will see it on the display, it tells you when to operate the main switch) otherwise it will not store the new settings/equipment.If sometimes you feel a little useless, offended and depressed always remember that you were once the fastest and most victorious sperm of hundreds of millions! -
Re: canon ir7105
hello teckat i havent checked canon forums in a while . Good to see you are still here minus the pictures lol.a machine is only as good as your tech : source:screwtape ; the scary oneComment
-
Re: canon ir7105
hi dear,
i did every thing coxail cable i ok but it will same problem not woking maybe there is reset how to reset function or limited function,
if any one have idea plz give me solution. thank'sComment
-
Re: canon ir7105
Use additional function to turn off limited function.Finisher must be turn on before copier!If it ain't broke, don't fix it
A picture is worth a thousand wordsComment
-
Re: canon ir7105
where is setting for turn off limited function?Comment
-
Re: canon ir7105
do u have a message on the control panel that says Limited Function ??
Is there a software version for the finisher displayed in service mode.
Check if the dip switch bank on the finisher controller are in the 'OFF' position.
If so change both switches to the 'ON' position and power cycling all components
dipswitch.jpg**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Comment
-
Re: canon ir7105
Enter Service Mode :
COPIER > OPTION > ACCPST-D , if the finisher is properly connected then the display looks like this :
ACC1 FINISHER 00001001 01 < --- ENTER 1 THEN OK, RESET 2x.
SHUT DOWN THE MACHINE AND THE FINISHER, TURN ON THE FINISHER AND THE MACHINE.Comment
Comment