Thanks Thanks:  0
Likes Likes:  0
Dislikes Dislikes:  0
Results 1 to 5 of 5

Thread: Sharp AR-M208

  1. #1
    Service Manager 250+ Posts
    Sharp AR-M208

    Tech2002's Avatar
    Join Date
    Aug 2008
    Posts
    262
    Rep Power
    21

    Sharp AR-M208

    Got a Sharp AR-M208 with a miss feeding/jam issue. It stalls just after going through the Fuser, leaving half of the paper fine and the other half, the lower half, in an accordion in the Fuser.

    This happens whether I am copying multiples or sending a job for offset finishing. This jam issue is intermittent but usually occurs when doing more than 5 copies or so.

    I was having an issue with the Off Set before this - swapped out the Shifter Motor didn't seem to make a difference, and the Fuser is brand new.

    Any suggestion would greatly appreciate. Thanks!


  2. #2
    Technician 250+ Posts
    Join Date
    Mar 2007
    Posts
    308
    Rep Power
    25
    Check the upper fuser roller gear and the gear on the main drive unit that drives it. Also check the gate that delivers the paper to the finisher or the middle output tray. I have seen the gate get in the way, also the main drive gear skip. If the fuser has been rebuilt definately check the main drive gear.
    Good luck.


  3. #3
    Senior member of CRS 2,500+ Posts
    Sharp AR-M208

    ZOOTECH's Avatar
    Join Date
    Jul 2007
    Location
    Insane Diego, CA
    Posts
    2,950
    Rep Power
    80
    What jam codes are you getting? Does it have the finisher option installed? Have you tried running aging mode without misfeed detection?

    "You can't trust your eyes, if your mind is out of focus" --

  4. #4
    Master Of The Obvious 10,000+ Posts
    Sharp AR-M208

    blackcat4866's Avatar
    Join Date
    Jul 2007
    Location
    Lapeer, Michigan
    Posts
    15,207
    Rep Power
    245
    What jam codes are you getting?

    I have a suggestion:
    Misfeeds (jam code PIN_END) from tray #1 &#2. Paper is left 1/2 way through the fuser and 2nd page 5mm short of the registration roller. Poor spring connection to separation charge. Stretch the contact spring for the separation charge.

    Like mtech says, the fuser drive gear on the rear frame wears the teeth sharp (haha-pun). It's extremely common, and I replace these gears at 150K intervals (every other PM). =^..^=

    Last edited by blackcat4866; 04-14-2009 at 12:58 AM.
    If you'd like a serious answer to your request:
    1) demonstrate that you've read the manual
    2) demonstrate that you made some attempt to fix it.
    3) if you're going to ask about jams include the jam code.
    4) if you're going to ask about an error code include the error code.


    blackcat: Master Of The Obvious =^..^=

  5. #5
    Senior Tech 100+ Posts Jaws's Avatar
    Join Date
    Oct 2007
    Location
    Lake Charles, LOuisiana
    Posts
    171
    Rep Power
    22

    Sensor

    It's the fuser sensor. The heat kills them. The gear would be making a noise leading you right to it.


Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Get the Android App
click or scan for the Copytechnet Mobile App

-=-=-=-=-=-


IDrive Remote Backup

Lunarpages Internet Solutions

Advertise on Copytechnet

Your Link Here