The trick to locating a specific sensor is this:
1) Look up the jam code to determine the specific sensor number, in this case: PS41
...
blackcat4866
blackcat4866
Master Of The Obvious
Last Activity: 11 hours ago
Joined: 07-28-2007
Location: Lapeer, Michigan
-
It looks like wrong toner, to me. Of all the brands that I've worked on, it was usually the Canons that endusers would re-fill the toner cartridge with...Leave a comment:
-
Your drive must be labelled: "Wipe Drive", or it is not....Leave a comment:
-
Did you ever do the color calibration? Four of your posts, and I still don't know. If you don't know how, just say so.Leave a comment:
-
Please, please, please start with a new corona unit. Stop trying to compensate for worn parts.Leave a comment:
-
Welcome to Copytechnet!!Leave a comment:
-
So you installed a HDD. Did you format it, etc, etc, etc?Leave a comment:
-
Creases are usually associated with moist paper. You should try fresh paper from your own source, not the customer's paper. A lot of jamming can also...Leave a comment:
-
If you do a printhead alignment print, it will be easier to see which colors are involved. Or something like this:...Leave a comment:
-
Where is that sample print?Leave a comment:
-
Yes, for curling. The idea is to help the pages lay flat and stack, rather than curl up into scrolls. They don't do a great job of compensating for that...Leave a comment:
-
In the past, when I have substituted fuser rollers that where the same physical measurements, but different thicknesses of materials, I have gotten fuser...Leave a comment:
-
This probably won't surprise you, but most of the tabletop Kyoceras were designed for high output. The more you run, the better it runs. If you're used...Leave a comment:
-
Welcome!Leave a comment:
-
I think I'd delete the print drivers and do fresh installs from scratch. If it continues I'd switch to another emulation or version of the driver.Leave a comment:
-
Leave a comment:
-
That was a good bit of work. It feels good, doesn't it. I mean finding the causes, then fixing.
Congratulations.Leave a comment:
-
I'm sure someone here could find firmware for you. Kyocera and Copystar use the same firmware. It's the same.
There is another simple solution....Leave a comment:
-
Tell us more about this "pinching". What is pinching? What is "eventually names"?
If English is not you native language,...Leave a comment:
-
I cannot identify a repeating pattern. Could this be generic toner or wrong toner?Leave a comment:
No activity results to display
Leave a comment: