GIUBOSS
Service Manager
Last Activity: 5 days ago
Joined: 07-17-2013
Location: Rome, IT
-
Have you tried with RFUT?... -
Try to lubricate itLeave a comment:
-
Did you also replace the charge roller cleaning roller?
Rebuild kits are also available if you want to save money and are familiar with drum un...Last edited by GIUBOSS; 1 week ago.Leave a comment:
-
Nothing doing... the 2710 would jam even with just one page, now it always says fuser door open... I disassembled it again and replaced the paper exit...Leave a comment:
-
This is certainly helpful, thanks, but I don't see the connection to the current topic......Leave a comment:
-
Hi, much appreciated of you but I already had it here, thanks anyway! -
Did you get your service manual yet? It's in American English.
If you want it, I'll need a destination email.
Dave -
Excellent, often disassembly and reassembly is enough to solve problems without wasting money. Possible faulty contacts or circuit boards blocked by power...Leave a comment:
-
Update: After several attempts, including replacing the paper pick-up and register clutches, I'm still having the same problem. Then, suddenly, by maneuvering...Leave a comment:
-
Check ceramic resistors for short circuitsLeave a comment:
-
I'm not sure if it's the paper feeders if the paper doesn't come out of any tray, though I'd clean the rubber rollers just to be sure. One test you can...Leave a comment:
-
Does it jam with all the paper trays?...Leave a comment:
-
Thanks. If I'm not mistaken, it should display a paper size mismatch warning once it's locked, but I'll check again.Leave a comment:
-
Hi, what do you need the firmware for, have you tried the online tool? I just looked it up, it's not written on the siteLeave a comment:
-
Thanks so much, I'm getting ready to fix this machine... have fun! -
-
Hi, I hope all the best, have you solved the problem of resetting the fuser counter? -
5 year old post .... they must have solved it a long time ago or replaced the box......Leave a comment:
-
In section 4.16.3 (page 324) remove the fuser unit, you see itLeave a comment:
-
Have you tried with the serial number and have you also contacted Kyocera Help? Have you also tried from the web with Admin?Leave a comment:
No activity results to display
Leave a comment: