Hi
Having serious problems with this
Its a IRA5151 with a C1 Staple finisher with an E505-0001 I have looked everywhere and what I found was that the machine doesnt recognise the new maincontroller fitted in the sorter.Checksum error on maincontroller pcb
In MODELIST, SORTER, ADJUST, all the settings are on 0. Tried to input values, but the machine 0's everything
I also set dipswitches 1 and 2 , powered machine, and then pressed softswitches 2 and 3 to initialise the board, it seems to initialise but as soon as the peripheral is connected the machine cycles briefly and then the E505-0001
Help would be greatly appreciated
Regards.
Having serious problems with this
Its a IRA5151 with a C1 Staple finisher with an E505-0001 I have looked everywhere and what I found was that the machine doesnt recognise the new maincontroller fitted in the sorter.Checksum error on maincontroller pcb
In MODELIST, SORTER, ADJUST, all the settings are on 0. Tried to input values, but the machine 0's everything
I also set dipswitches 1 and 2 , powered machine, and then pressed softswitches 2 and 3 to initialise the board, it seems to initialise but as soon as the peripheral is connected the machine cycles briefly and then the E505-0001
Help would be greatly appreciated
Regards.
Comment